User's Manual

701-070801 Rev A This document contains proprietary information,
see proprietary statement on first page.
Page 76 of 85
Figure 90 System-Configuration-Xcvr-Action Page
Table 48 System-Configuration-Xcvr-Action Page Actions
Event Action
Start button pressed
Configure transceiver for configuration operation. Change state
of operation to Underway. Hide or disable Start button. Hide or
disable BACK button.
Stop button pressed
Configure transceiver for normal operation. Change state of
operation to Idle. Show or enable Start button. Show or enable
BACK button. Hide or disable Stop button.
BACK key pressed Invoke System-Configuration-Xcvr-Transceiver page.
HOME key pressed Return to System-Configuration-Function page.
6.4.3 R
EUSABLE COMPONENTS
The following sections describe data entry components designed to allow consistent data entry
throughout the system. This includes components for all the common quantities, such as frequencies,
sub-audible tones, NAC codes, etc.
6.4.3.1 Channel Number Entry
The Channel-Number-Entry dialog shall allow the operator to input preset channel numbers. Preset
channel numbers are integers ranging from 0 to 1024. The operator enters a channel number using the
virtual keypad. Digits keys on the keypad shall be touchable directly, or selectable via the cursor/value
controls. An entry can be cleared (restarted) by pressing the “C” button. Entry shall be completed by
pressing the “Ok” button. The Channel-Number-Entry dialog is depicted in Figure 91.