User's Manual

701-070801 Rev A This document contains proprietary information,
see proprietary statement on first page.
Page 63 of 85
Figure 74 Scan-Group-Function Dialog
Table 32 Scan-Group-Function Dialog Actions
Event Action
Add button pressed Invoke Scan-Group-Add dialog.
Change button pressed Invoke Scan-Group-Change dialog.
Delete button pressed Invoke Scan-Group-Delete dialog.
HOME key pressed Return to Home page.
6.4.2.9.1 Add Scan Group
The Scan-Group-Add pages shall allow the operator to add a new scan group to a transceiver’s scan
group list and configure the newly added group’s properties.
The first page in the sequence shall be the Scan-Group- Add-Transceiver page. This page shall allow the
operator to specify the transceiver for which the scan group will be added. Only transceivers installed in
the system shall be selectable. At this time, Motorola does not allow scan groups to be added to a
transceiver by any means other than their CPS software. Therefore, APX transceivers shall be disabled
or hidden on this page. The page is depicted in Figure 75 and the page’s Action/Event table is contained
in Table 33.
Figure 75 Scan-Group-Add-Transceiver Page
Table 33 Scan-Group-Add-Transceiver Page Actions
Event Action
RT1 button pressed Select transceiver 1 and invoke Scan-Group-Number page.
RT2 button pressed Select transceiver 2 and invoke Scan-Group-Number page.
RT3 button pressed Select transceiver 3 and invoke Scan-Group-Number page.
HOME key pressed Return to Scan-Group-Function page.
The Scan-Group-Add-Number page shall allow the operator to select the number of the scan group to
add. Only groups that are not programmed shall be displayed. The page is depicted in Figure 76 and
the page’s Action/Event table is contained in Table 34.