User's Manual

701-070801 Rev A This document contains proprietary information,
see proprietary statement on first page.
Page 42 of 85
Figure 47 Preset-Channel-Function Dialog
Table 10 Preset-Channel-Function Dialog Actions
Event Action
Add button pressed Invoke Preset-Channel-Add dialog.
Clone button pressed Invoke Preset-Channel-Clone dialog.
Change button pressed Invoke Preset-Channel-Change dialog.
Delete button pressed Invoke Preset-Channel-Delete dialog.
HOME key pressed Return to Home page.
6.4.2.8.1 Add Preset Channel
The Preset-Channel-Add pages shall allow the operator to add a new channel to a transceiver’s channel
list and configure the newly added channel’s properties. These pages utilize the “Wizard” paradigm
where each channel property is configured on a separate page. This is useful for preset channels
because the properties have dependencies. For example, an AM channel should not allow for
configuring sub-audible tones since they are not used in AM. Another example, network access codes
should not be available for non-P25 channels. The “Wizard” paradigm ensures only applicable properties
are displayed to the operator for configuration.
The first page in the sequence shall be the Preset-Channel-Transceiver page. This page shall allow the
operator to specify the transceiver for which the channel will be added. Only transceivers installed in the
system shall be selectable. At this time, Motorola does not allow channels to be added to a transceiver
by any means other than their CPS software. Therefore, APX transceivers shall be disabled or hidden on
this page. The page is depicted in Figure 48 and the page’s Action/Event table is contained in Table 11.