User's Manual

701-070801 Rev A This document contains proprietary information,
see proprietary statement on first page.
Page 16 of 85
RTX
NOT INSTALLED
Figure 13 Dashboard View – Transceiver Not Installed
6.4.1.4 Active-Transceiver-View
The Active-Transceiver-View contains detailed information on the operating state of the active
transceiver, and allows the operator to control the transceiver. From within this view the operator can
perform activities such as change channels, enter/exit direct mode, turn on/off encryption, etc. This also
contains more detailed state information than is displayed in the Dashboard-View. The Active-
Transceiver-View is depicted in Figure 14.
Figure 14 Active Transceiver View
The Transceiver-Label contains the identifier of the active transceiver. Valid values are RT1, RT2, RT3,
RT4, and RT5. The Transceiver-Label shall behave as a button that when pressed, shall toggle the
transceiver’s on/off state. The label press shall be either by direct touch, or by cursor/value/enter
control.
The Indicator-Bar displays the current state of the active transceiver. The following table lists all the
indicators that can appear in the Indicator-Bar, what they mean, and when they are to be displayed.