Operator's Manual
Table Of Contents
- INTRODUCTION 4
- Basic Operation
- Front Panel & Controls
- The Home Page
- Setting the Display Brightness
- Setting the Volume Level
- Selecting a Preset Channel Using the Cursor/Value Knob
- Selecting a Channel Using the Keypad
- Selecting a Channel by Alphanumeric Identifier
- Selecting the Manual Channel
- Using the Direct/Repeat Feature
- Receiving/Transmitting
- Enabling/Disabling Transceivers
- Using The Edit Page
- Enhanced System Features
- Encryption Features
- Programming Preset Channels
- Configuring the C-5000
- RSS SOFTWARE DESCRIPTION AND PROGRAMMING
- Glossary
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
C-5000 Operator’s Manual
150-041102 REV. A Page 55 of 61
FILE MAINTENANCE MENU – Displayed by pressing F6 from the Main Menu. This menu is a VERY
CRUDE file maintenance menu for creating new directories on the PC Hard Disk or for Deleting Archive files. It
would be MUCH better to ignore this capability and perform all file maintenance tasks inside of Windows using
Explorer. Functions available include:
F2 – Create a new directory. (That’s DOS-speak for FOLDER!) - Press this, followed by entry of new directory
path, followed by F2 again to finish the directory creation
F5 – Delete Archive file. Press this and the screen will change to a listing of Archive files currently stored on the
PC Hard Disk. Highlight the file to be deleted and press F5 again.
SERVICE SOFTWARE CONFIGURATION – Displayed by pressing F9 from the Main Menu. This is the
gateway to further menus that allow configuration of the software on the PC. It will cover such things as file
locations on the hard disk and colors of the display screen.
F3 – Go to the PC CONFIGURATION Screen
F7 – Go to the SCREEN Color Configuration Screen
CONFIGURE PATHS AND PORT – Displayed by pressing F9 ! F3 from the Main Menu. This screen allows
configuration of the RSS Software, and testing of the communications between the PC and the ITM. These settings
need only be made one time after the software is initially installed and should not require further adjustment. Leave
MEMORY OPTIMIZATION = DISABLED. This is used on VERY old PCs. Adjust the COMM PORT setting for
the one you will use.where the interface cable will be attached to the PC leading to the RT-5000. This is typically
COM 1 on a laptop, but may be COM 2. When finished, press F8 to save the configuration to the PC Hard Disk.
SCREEN COLORS – Displayed by pressing F9 ! F7 from the Main Menu. This screen allows the various menu
entries and highlights on other screens to assume different colors. Simply move the highlight to the area that is to be
changed and use the up and down arrows to see what colors are available. As the different color combinations are
selected, the screen immediately shows the results. When all the colors have been setup as desired, press the F8 key
to save the selections to the PC Hard Disk. The program will then use the selected color patterns until changed.