Operator's Manual
Table Of Contents
- INTRODUCTION 4
- Basic Operation
- Front Panel & Controls
- The Home Page
- Setting the Display Brightness
- Setting the Volume Level
- Selecting a Preset Channel Using the Cursor/Value Knob
- Selecting a Channel Using the Keypad
- Selecting a Channel by Alphanumeric Identifier
- Selecting the Manual Channel
- Using the Direct/Repeat Feature
- Receiving/Transmitting
- Enabling/Disabling Transceivers
- Using The Edit Page
- Enhanced System Features
- Encryption Features
- Programming Preset Channels
- Configuring the C-5000
- RSS SOFTWARE DESCRIPTION AND PROGRAMMING
- Glossary
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
C-5000 Operator’s Manual
150-041102 REV. A Page 38 of 61
SYS #2:2=NEXT 3=BACK
TONE BOARD CTCSS-NO
• Use the cursor/value knobs to tell the C-5000 if a CTCSS tone board is present. Press the MODE button to
display the next menu page.
SYS #2:2=NEXT 3=BACK
TONE BOARD DCS-NO
• Use the cursor/value knobs to tell the C-5000 if a DCS tone board is present. Press the MODE button to display
the next menu page.
SETUP RADIO #2
HOME=EXIT 2=REVIEW
• Press the HOME button to exit the radio setup menu pages, or press the MODE button to review the current
settings.
Setting Passwords
This section drills down into the password setup sub-menu pages. Refer to the section on configuring the C-5000
for details on how to reach these menu pages. This section assumes we want to change password 1. The process is
the same for password 2. We pick up at the following display page.
SETUP: 2=NEXT 3=BACK
ENTER=CHG PASSWORD 1
• Press the ENTER button to begin the password changing process. The display will appear as follows.
ENTER NEW PASSWORD 1
#=.... <ENTER>
• Use the keypad to input the new password, and press the ENTER button.