Operator's Manual
Table Of Contents
- INTRODUCTION 4
- Basic Operation
- Front Panel & Controls
- The Home Page
- Setting the Display Brightness
- Setting the Volume Level
- Selecting a Preset Channel Using the Cursor/Value Knob
- Selecting a Channel Using the Keypad
- Selecting a Channel by Alphanumeric Identifier
- Selecting the Manual Channel
- Using the Direct/Repeat Feature
- Receiving/Transmitting
- Enabling/Disabling Transceivers
- Using The Edit Page
- Enhanced System Features
- Encryption Features
- Programming Preset Channels
- Configuring the C-5000
- RSS SOFTWARE DESCRIPTION AND PROGRAMMING
- Glossary
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
C-5000 Operator’s Manual
150-041102 REV. A Page 37 of 61
SYS #2:2=NEXT 3=BACK
RT-7200 PRESENT-NO
• Use the cursor/value knobs to tell the C-5000 if an RT-7200 is present. Press the MODE button to display the
next menu page.
SYS #2:2=NEXT 3=BACK
GUARD #1 PRESENT-YES
• Use the cursor/value knobs to tell the C-5000 if a Guard is present. Press the MODE button to display the next
menu page.
SYS #2:2=NEXT 3=BACK
ENTER=SETUP GUARD #1
• This page only appears if a guard is present. Press the ENTER button to configure the first Guard channel.
Refer to the preset channel programming section for details on the menu pages that appear. Press the MODE
button to display the next menu page.
SYS #2:2=NEXT 3=BACK
GUARD #2 PRESENT-YES
• This page only appears if a second Guard is possible. Use the cursor/value knobs to tell the C-5000 if a second
Guard is present. Press the MODE button to display the next menu page.
SYS #2:2=NEXT 3=BACK
ENTER=SETUP GUARD #2
• This page only appears if a second guard is present. Press the ENTER button to configure the second Guard
channel. Refer to the preset channel programming section for details on the menu pages that appear. Press the
MODE button to display the next menu page.