Operator's Manual

C-5000 Operator’s Manual
150-041102 REV. A Page 27 of 61
Programming Preset Channels
WARNING: CONFIGURING THE C-5000 MUST BE PERFORMED BEFORE PRESET CHANNELS
ARE PROGRAMMED FOR THE UNIT TO OPERATE PROPERLY !!!!
Programming Preset Channels Using the Front Panel
Although Wulfsberg highly recommends using the PC based Remote Programmer software to program preset
channels for the C-5000, they can be programmed from the front panel. The process is as follows.
• Ensure you are on the HOME PAGE.
• Press the PROG button. If the C-5000 has been programmed to require a password to enter this mode, you will
be prompted to enter a password, as follows.
ENTER PASSWORD 2
#=.... <ENTER>
• Input the appropriate password using the keypad and press the ENTER button.
• Press the MODE button until the following display page appears.
PROG: 2=NEXT 3=BACK
<ENTER>= CHANNELS
• Press the ENTER button to invoke the CHANNEL MAIN MENU PAGE, depicted below.
PROG: CHANNEL
2=ADD 3=CHG 4=DEL
• Press the MODE button to add a new channel or the EDIT button to modify an existing channel. The pages are
nearly identical for both functions. The illustrations that follow assume we are adding a channel, i.e. we pressed
the MODE button.