Operator's Manual

C-5000 Operator’s Manual
150-041102 REV. A Page 26 of 61
Manually Loading Encryption Keys
It may be desirable to manually load the encryption keys contained in a RT-5000 digital transceiver. This can be
accomplished as follows.
• Ensure you are on the HOME PAGE, and the cursor is on an encryption capable channel.
• Press the PROG button. You will be prompted to enter a password, as follows.
ENTER PASSWORD 2
#=.... <ENTER>
• Input the appropriate password using the keypad and press the ENTER button.
• Press the MODE button until the following display page appears.
PROG: 2=NEXT 3=BACK
<ENTER>= KVL LOAD
• Press the ENTER button to invoke the KVL LOAD PAGE, depicted below.
←
←←
←
START KVL LOAD
RADIO=1 ITM=VHF138
• Use the cursor/value knobs to select the radio and desired Internal Transceiver Module (ITM) you want to load
the encryption keys . The RT-5000 can have up to two modules covering two frequency bands per unit. Only
available options will be displayed. Once the desired radio and ITM have been selected, press the UPPER
SOFT KEY to initiate the load process. The display will appear similar to the following.
←
←←
←
END KVL LOAD
RADIO #1 IN KVL MODE
• Connect the Key-loader device to the transceiver data port. Load the desired keys using the procedure for the
key-loader as prescribed its manufacturer.
• Press the UPPER SOFT KEY to acknowledge the key load is complete. The display will return to the main
KVL LOAD PAGE, allowing you to select another radio and/or digital transceiver module to load.
• When finished loading the keys to all desired modules, press the HOME button to return to the HOME PAGE.