Operator's Manual
Table Of Contents
- INTRODUCTION 4
- Basic Operation
- Front Panel & Controls
- The Home Page
- Setting the Display Brightness
- Setting the Volume Level
- Selecting a Preset Channel Using the Cursor/Value Knob
- Selecting a Channel Using the Keypad
- Selecting a Channel by Alphanumeric Identifier
- Selecting the Manual Channel
- Using the Direct/Repeat Feature
- Receiving/Transmitting
- Enabling/Disabling Transceivers
- Using The Edit Page
- Enhanced System Features
- Encryption Features
- Programming Preset Channels
- Configuring the C-5000
- RSS SOFTWARE DESCRIPTION AND PROGRAMMING
- Glossary
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
C-5000 Operator’s Manual
150-041102 REV. A Page 16 of 61
..1 506.987R T... FM
S H 509.987T T.17 ..
• Press the ENTER button to move the cursor under the “T” of the transmit tone field.
• Rotate the VALUE knob clockwise once. The transmit tone field will show “…” as depicted below.
..1 506.987R T... FM
S H 509.987T T... ..
Selecting a CTCSS Tone
• Move the cursor under the least significant digit of the tone field you want to change. The illustration below
assumes we want to change the receive tone.
..1 506.987R T.17 FM
S H 509.987T T.17 ..
• Rotate the VALUE knob clockwise to increment the tone, or counterclockwise to decrement the tone. Keep
rotating the VALUE knob until the desired tone is displayed.
Appendix A lists the frequencies associated with the Wulfsberg CTCSS tone numbers.
Selecting a DCS Tone
• Move the cursor under the most significant digit of the tone field you want to change. The illustration below
assumes we want to change the receive tone.
..1 506.987R T.17 FM
S H 509.987T T.17 ..
• Rotate the VALUE knob clockwise to increment the tone, or counterclockwise to decrement the tone. Continue
rotating the VALUE knob until the most significant digit is that of the desired tone.
NOTE: