Operator's Manual

C-5000 Operator’s Manual
150-041102 REV. A Page 15 of 61
• Move the cursor under the field containing the channel property you want to edit.
• Use the VALUE knob to change the property to the desired value.
• Press the HOME button to return to the HOME PAGE. The changes will remain in effect until the channel is
changed.
The cursor cannot be moved under channel property fields that are not editable.
Editing a Manual Channel
To change the properties of a manual channel, do the following.
• On the HOME PAGE, select the manual channel you want to edit.
• Press the EDIT button to display the EDIT PAGE.
• Move the cursor under the field containing the channel property you want to edit.
• Use the VALUE knob to change the property to the desired value.
• Press the HOME button to return to the HOME PAGE and save the manual channel’s current state.
The cursor cannot be moved under channel property fields that are not editable.
Changing PL & DPL (CTCSS and DCS) Tones
The C-5000 supports both CTCSS (PL) and DCS (DPL) tones. The tone used by a channel can be temporarily
overridden on the EDIT PAGE. You can select any valid tone, or turn tones off. (Channels programmed to use the
ITM of a Guard receiver module in a RT-5000 cannot be changed)
Turning Tones Off
• Move the cursor under the “T” of the receive tone field, as depicted below.
..1 506.987R T.17 FM
S H 509.987T T.17 ..
• Rotate the VALUE knob clockwise once. The receive tone field will show “…” as depicted below.
NOTE:
NOTE: