Operator's Manual
Table Of Contents
- INTRODUCTION 4
- Basic Operation
- Front Panel & Controls
- The Home Page
- Setting the Display Brightness
- Setting the Volume Level
- Selecting a Preset Channel Using the Cursor/Value Knob
- Selecting a Channel Using the Keypad
- Selecting a Channel by Alphanumeric Identifier
- Selecting the Manual Channel
- Using the Direct/Repeat Feature
- Receiving/Transmitting
- Enabling/Disabling Transceivers
- Using The Edit Page
- Enhanced System Features
- Encryption Features
- Programming Preset Channels
- Configuring the C-5000
- RSS SOFTWARE DESCRIPTION AND PROGRAMMING
- Glossary
- Appendix A – CTCSS (PL) Tone Codes
- Appendix B – Mode 2 Operation
C-5000 Operator’s Manual
150-041102 REV. A Page 13 of 61
Enabling/Disabling Transceivers
Disabling (Turning Off) a Transceiver
• Place the cursor under the R/T status indicator. The following illustration shows the cursor under Radio #1’s
status indicator.
1 123
→
→→
→
LUKEAFB TWR1
2
φ
φφ
φ
..1 TACTICAL-001
• Rotate the VALUE knob once in either direction. The display will indicate the radio has been turned off, as the
following illustrates.
. RADIO OFF
2
φ
φφ
φ
..1 TACTICAL-001
Enabling (Turning On) a Transceiver
• Place the cursor under the radio’s status indicator. The following illustration shows the cursor under Radio
#2’s status indicator.
1 123
→
→→
→
LUKEAFB TWR1
. RADIO OFF
• Rotate the VALUE knob once in either direction. The display will indicate the radio has been turned on, as the
following illustrates.
1 123
→
→→
→
LUKEAFB TWR1
2
φ
φφ
φ
..1 TACTICAL-001