Installation Manual

Page 5-16 Publication No. 150-041118
Section 5 – Configuration and Programming Rev. A
Sep 2001
..1 506.987R T.17 FM
S H 509.987T T.17 ..
• Rotate the VALUE knob clockwise to increment the tone, or counterclockwise to decrement the tone. Continue
rotating the VALUE knob until the most significant digit is that of the desired tone.
• Move the cursor under the least significant digit of the tone, as illustrated below.
..1 506.987R T023 FM
S H 509.987T T.17 ..
• Rotate the VALUE knob clockwise to increment the tone, or counterclockwise to decrement the tone. Keep
rotating the VALUE knob until the desired tone is displayed.
Changing Transmit Power
The C-5000 supports the selection of high and low transmit power. Normally high power is used, however, if
interference or other transmit issues are experienced, low power may be selected to help remedy the issue. If you
have a radio that supports multiple power levels, such as the RT-5000, you can alter the power setting from the
EDIT PAGE as follows.
• Move the cursor under the transmit power field, as depicted below.
..1 506.987R T.17 FM
SH509.987T T.17 ..
• Rotate the VALUE knob clockwise once. The power indicator will toggle between high and low with each turn
of the VALUE knob.
Changing Modulation Type
The modulation type can be only be changed on the manual channel, and can only toggle between AM and FM. To
change the manual channel’s modulation type, do the following.
• Move the cursor under the modulation field, as depicted below.
A “0-7” in the first position means you are selecting a DCS
tone. This is a special kind of tone rarely used.