Installation Manual

C-5000 COMMUNICATION MANAGEMENT CONTROLLER

INSTALLATION MANUAL

Publication No. 150-041118 Page 1-1

Rev A Section 1 - Introduction

Sep 2001

SECTION 1 - INTRODUCTION

IMPORTANT

This manual contains information pertaining to the installation of the C-5000

Communication Management Controller with FLEXCOMM II and FLEXCOMM I.

FLEXCOMM II consists of the RT-5000 Transceiver, appropriate antennas, and optional

equipment as required. FLEXCOMM I consists of the RT-9600 Transceiver, RT-9600F

Transceiver, RT-7200 Transceiver, and optional combinations of up to three of the

following FLEXCOMM Transceivers: RT-30, RT-118, RT-138(F), RT-406F, RT-450,

appropriate antennas, and optional equipment as required. The C-5000 can also

interface with combined applications of FLEXCOMM II and FLEXCOMM I, i.e., a hybrid

RT System configuration that consists of both RT-5000 and FLEXCOMM I Transceivers.

1. Using This Manual

This manual is divided into the following sections:

SECTION 1- INTRODUCTION

This section contains an overview of the contents of this manual and lists the components

installed in FLEXCOMM I and FLEXCOMM II systems using the C-5000.

SECTION 2 - SYSTEM INSTALLATION

This section covers the general system characteristics, interface capabilities and power

requirements.

SECTION 3 - MECHANICAL INSTALLATION

This section contains system component dimensions, the racking requirements, weights, and

component installation data.

SECTION 4 - FLEXCOMM II ELECTRICAL INSTALLATION

This section contains the wiring information to install the C-5000 Control Unit with the

FLEXCOMM II Transceiver in an aircraft.

SECTION 5 - FLEXCOMM I ELECTRICAL INSTALLATION

This section contains the wiring information to install the C-5000 Control Unit with the

FLEXCOMM I Transceiver in an aircraft.

SECTION 6 - SYSTEM CONFIGURATION AND PRESET CHANNEL PROGRAMMING

This section contains the system configuration and preset channel programming procedures

for the system.

SECTION 7 - SYSTEM CHECKOUT

This section contains checkout procedure for the system after installation.