Installation Manual

C-5000 COMMUNICATION MANAGEMENT CONTROLLER

INSTALLATION MANUAL

Publication No. 150-041118 Page 5-7

Rev. A Section 5 – Configuration and Programming

Sep 2001

Turning the System On and Off

To power the C-5000 ON, press and hold the ON button for approximately one second. Several version number and

When initialization is complete, the HOME PAGE will appear on the display.

To power the C-5000 OFF, press and hold the ON button for several seconds. The following message flashes on the

display several times:

!!!USE CAUTION !!!

TURNING SYSTEM OFF

Continue to hold the ON button until the message stops flashing and the display turns off.

Setting the Display Brightness

When you first power ON the C-5000, the display is at its maximum brightness. To adjust the brightness level,

ensure you are on the HOME PAGE, then press the DIM button. The display will appear as follows.

←

←←

←

UP CHANGE DISPLAY

←

←←

←

DOWN BRIGHTNESS

Press the UPPER SOFT KEY to brighten the display. Press he LOWER SOFT KEY to dim the display. Press the

HOME button to return to the HOME PAGE.

Setting the Volume Level

When you first power ON the C-5000, the volume level will be reset to the level that was active when the unit was

powered down. You can change the volume level as follows.

Radio 1

• Place the cursor on the top line of the display.

• Tune to a channel with activity on it or press the TEST button. This will unsquelch the radio, allowing you to

hear the current volume level.

• Rotate the INNER VOLUME knob clockwise to increase the volume level, or counterclockwise to decrease the

volume level.

Radio 2

• Place the cursor on the bottom line of the display.