User's Manual

FLITELINE AVIONICS SYSTEM
PILOT’S GUIDE
Publication No. 150-047012 Page 23
Rev. D Dec 2005
CVN-252 Controls (Series III and FliteLine Interface continued…)
---
ACT
1
ON BRGRAD

111.40
Three dashes on the bottom line indicate a flag
condition. This flag means that RAD or BRG has
been selected on the FUNCTION SELECTOR
switch but cannot be displayed because of
insufficient signal or during VOR station passage.
L0C
ACT
1
ON BRGRAD

111.40
When the top (active) frequency is a localizer
station, bearing or radial cannot be displayed.
Setting the FUNCTION SELECTOR switch to BRG
or RAD will cause the letters LOC to appear on the
bottom line instead of the standby frequency. This
is a reminder that this display cannot be used for
bearing or radial data while on an ILS approach.
NOTE: When LOC is displayed, return the
FUNCTION SELECTOR to the ON
position so that the standby frequency is
displayed instead.
264.0°
ACT
1
ON BRGRAD

111.40
The number 1 below the letters ACT represent Nav
System 1 when more than one NAV System is
installed. This number is fixed at the time of
installation.