User's Manual

FLITELINE AVIONICS SYSTEM
PILOT’S GUIDE
Page 10 Publication No. 150-047012
Dec 2005 Rev. D
CVC-152 Controls (Series III, FliteLine, and ARINC 410 Interfaces Continued…)
CHELTON
COM
PWR
124.950
ACT
1
25k TST8.33k
124.950
MODE
VOL
TUNE
Frequency Knobs
The right outer knob tunes the transmit/receive
frequency in whole MHz steps (118, 119, 120,
etc.). The right inner knob tunes in 25 or 8.33
kHz steps (refer to the table on page 10).
Frequency Transfer Button
The right inner knob also functions as a
pushbutton for switching the active and
standby frequency.
Press and release to exchange active and
standby frequencies. Press and hold 2
seconds to remove the standby frequency so
that the active frequency can be changed
directly with the frequency knobs. Press and
hold 2 seconds again to restore the standby
frequency.
Press and hold for 7 seconds or longer to set
the active frequency to 121.50 MHz, and put
the radio into the active tuning mode.
CHELTON
COM
PWR
124.950
ACT
1
25k TST8.33k
124.950
MODE
VOL
TUNE
Inner Knob
Volume Control (Optional) - Inner knob
controls the receiver audio volume. Volume
Level Annunciator appears only when volume
is being adjusted and is removed from display
two seconds following adjustment.