User's Manual

N5106 User manual
Page 38
Save as ： to save the changed connection setting of network as other setting. The system
setting will not be covered, and it will prompt;
Profile
： to select the connection method to visit network among WAP, MMS and Java；
View
： to view the name, homepage and bearer type and so on of current connection；
Tap the connection of non-system setting，and then enter the window of connection setting
to complete the following operations：
Profile title：to view or edit the name of profile；
MMSC: look over or edit the number of MMS;
Homepage：to view or change the address of homepage；
Gateway ： include IP address （ for example 010.000.000.172 for CMCC）； Port
number (for example 9201 for CMCC)；Connect type：to select between HTTP
and WSP。
Bearer type：to select the bearer type of network visited, use side up/ down key to highlight
the type you wanted, tap Select to activate it：
♦ GPRS only：only use GPRS network；
♦ CSD only：only use CSD network。
GPRS settings：to change the connection setting of GPRS，select the setting needed to
change, tap Select to enter corresponding window：
♦ APN：to set the name of network；
♦ User name：user name of network service；
♦ Password：password of network service。
CSD settings：to change the connation setting of CSD，select the setting needed to
change, tap Select to enter corresponding window：
♦ Dial-up number：dial-up number for network service；
♦ Call type：to set the call type between ISDN and Analogue；
♦ User name：user name of network service；
♦ Password：password of network service。
DNS settings
： input DNS address 1 and DNS address 2。
4.9 Calibration
When you feel the phone cannot react accurately after you use the touchpen to tap some place on the
screen, calibration is needed, which ensures the touch screen of phone can react correctly for tapping action.
1. on the screen of “Settings”，tap “Calibration” to enter the calibration screen；
2. use the touchpen to tap the center of cross according to the hint. After three times, the screen
displays “Calibration OK”。
4.10 Reset
If you enable “PIM protect”, then when you try to reset you phone, it will pop up “Input security
password”. Only if you input the correct password can you carry on Reset settings/Reset all
4.10.1 Reset settings
“Reset settings” is to resume all original default value. After selecting, the mobile phone will prompt
“Reset settings”. After confirming, the system resumes the default value and prompts “Reset setting…”.
Using this function will not clear the data of phonebook and message saved by you own. It only changes the