User manual

User Manual
• Tamb: Show the ambient temperature automatically measured by the camera.
Note: Altering Tamb value is unavailable.
• Press Button “Menu” or “OK” to confirm the change and exit the “Target Setup”
menu.
• Press Button “C” to exit the “Target Setup” menu.
• Press Button “C” again to return to the live image
Sub Menu Time
• Press Button “Menu” or “＞” to enter the option “Setup”. Press Button “ ” to ∨
highlight “Time”
• Press Button “Menu” or “OK” to enter the “Time Setup” option
• The setup parameters menu will then appear. Press “ ”and“ ”∧∨ to move between
each setting, press Button “＜”and “＞” to alter the values
• Press Button “Menu” or “OK” to confirm the change and exit the “Target Setup”
menu.
• Press Button “C” to exit the “Target Setup” menu.
• Press Button “C” again to return to the live image
Note:
• Time refreshes in real time when the camera is working. Resetting the
parameters under the menu above interrupts refreshing. After setup, time
goes on to refresh on time.
• Resetting time is essential when it takes more than half an hour to replace
the battery