User manual

User Manual
Static Temperature Measurement
• Keep the camera steady when you have the image in focus, press Button “OK” to
freeze the live image. The word “Frozen” will appear on the screen to indicate the
current status of the image.
• Press any key except OK to cancel this indication if necessary.
• Press Button “ ”, “ ”, “∧∨＜”and “＞” to move the center cursor
• The value in top of the screen shows the temp of the moving cursor
• Imaging performance varies from different temperature range and palette.
• Setting the temperature range is the same as in dynamic real time temperature
measurement
Main Menu Introduction
• This section covers all the main menu options and their sub menus. The main
menu is brought up on the screen by pressing Button “Menu”
• The menus can be navigated by pressing Button “ ”, “ ”, “∧∨＜”and “＞”, the
highlighted option is confirmed by pressing Button “Menu” or “OK”
• Setup Analysis: Allows for the camera functions to be setup
• Setup Target: Allows for temperature measurement parameters to be set up
• Setup Time: Allows for the date and time to be set
• Setup Default: Resume the factory configured value of all the parameters
• File Browse: To preview and open saved images
• File Delete All: To delete all the saved images
• Analysis Spot: Allows up to four spot measurements to take place on saved or
frozen images
• Analysis Area: Allows up to four rectangular area measurements to take place
on saved or frozen images, displaying maximum, minimum or mean temperature
• Analysis Line: Allows line profile measurement to take place on saved or frozen
images
• Analysis Isotherm: Allows for an isotherm to be placed on live, saved or frozen
images