User manual

IR518 Thermal Imager User Manual
4
 If the observation is over or in holding state, please timely cut off the power so as to effectively
extend the imager lifetime.
 Pay attention to the protection of the various cables and wires that connected with thermal
imager.
 Do not clean with chemical solvent, diluents. The clean, soft and dry flannelette is available.
As the thermal imager lens had been coated an antireflective film layer and often clean will
damage the coating, the optical surfaces of the imager lens should only be cleaned when visibly
dirty. Please avoid touching the exposed lens surface, as the acid substance on the print will
damage the coatings and lens substrates. Use only a proprietary lens cleaning tissue.