User manual

IR518 Thermal Imager User Manual
3
Chapter 2 Precautions and maintenance
 Do not direct the IR518 Thermal Imager at very high intensity radiation sources such as the
sun, carbon dioxide lasers or arc welders etc.
 Do not direct the IR518 Thermal Imager at high temperature target when power-on the IR518
Thermal Imager.
 When the IR518 Thermal Imager is not in use or is to be transported, ensure that the battery
is taken out and the unit is stored in the protective carry case.
 The IR518Thermal Imager integrates precision optical equipment and static-sensitive
electronics, so please do not casually place, knock, or shock the thermal imager and
accessories, and make it far off the static to avoid any damages.
 Never attempt to disassemble or open the imager body, as this action will void the warranty.
Contact manufacturer for calibration or repair.
To ensure that the IR518 Thermal Imager is kept in a good working condition and remains fully
functional operation, the following guidelines should be respected at all times:
 All User Manuals and leaflets should be read thoroughly before proceeding with operation of
the equipment, please contact us if there is any unclear.
 Keep the IR518 Thermal Imager steady during operation.
 Do not use the IR518 Thermal Imager beyond the specified operation condition scope.
 Do not apply the non-fitted thermal imager adapter.
 Do not frequently power on/off the imager. The time between on and off should be not less
than 20 sec.
 Do not pull in/out all the cables when the imager is power-on; and highly recommend to cut off
the power of all the connected electric systems when pull in/out the cables.