User manual

IR518 Thermal Imager User Manual
15
6.3 Help menu
Choose “Help” then press“M”to enter to Help Menu. Press“＋”、“－”to view the helping
information. Press “M” again to exit this menu.
6.4 Button instruction setting
Select “Note.” then press “M” to choose whether the button instruction shall be displayed or not.
We suggest users to open the button instruction.
6.5 Stand-by mode
You can press button“M” to enable/disable of the standby mode. To set “Standby as
4/10/15/20min”to enable the feature.
If under the stand-by mode, when the IR sensor besides the eye-piece detect the human eye, the
LCD screen will be working, when your eye leaves the eye-piece, the screen will shut down and
the camera will be power off after 4 min, 10 min, 15min or 20 min.
If the stand by mode is off, no matter the eye is close or not, the LCD screen will always be light.
The camera will be power off automatically after 10 min if there is no operation during this period.
6.6 Crossed hair cursor
User can choose the crossed hair cursor . Choose“Cursor” then press“M”to switch the cursor
setting .When it’s set as 0, there will be no cursor. When set as 1 to 3, you will see the following
image.