User manual

IR518 Thermal Imager User Manual
12
b) Aim the Thermal Imager to the target.
C) The default mode is AUTOMATIC MODE which provides user with a clear image after
simply focusing. User can also adjust the brightness and contrast to get a qualified
satisfying image.
. Adjust the focus manually to get clear image.
Note: When human eye left the eye detector, the imager will enter stand-by mode, when eyes
get close to the eye detector, the LCD will lighten again!
The shutdown time can be chosen in the menu as 4 minutes, 10 minutes , 15minutes and 20
minutes.
10) Function Brief: Detailed button operation instructions such as Brightness and Contrast
adjustment, Polarity selection, cursor choosing and checking, setting language and button
instruction, parameters save, freeze, save and playback pictures, record and playback infrared
video, focus adjustment, non-uniformity calibration and etc functions, please refer to
OPERATION INSTRUCTIONS in the next section.
11) If the stand-by mode is off, the camera will power off automatically after 10 min if there is no
operation.
12) Power-off: When operation completed, firstly put back the lens cover, then press and hold the
power button till the shut-down progress bar on the screen reach its right end. After that,
remove the cables from the sight by holding the lock pin on the cable and pulling it out. Do not
pull the cable by force, otherwise damage may occur！