User manual

User Manual
21
Power cable is not connected to the camera well. Pull the
cable out and properly reinsert it into the Video/ Power
interface on the camera body.
Button power is not properly pressed. Wait for 20 seconds
at least and then repress the button power for 2 seconds.
Low contrast or obscure image Contrast is inappropriate. Adjust contrast or gain value
manually.
Focus is not appropriate. Adjust focus to a suitable degree.
Dioptre of the viewfinders is inappropriate. Adjust dioptre till
satisfying.
Non uniformity appears in the image. Perform
non-uniformity calibration manually.
Image is not properly displayed in the viewfinders because
a color palette is used. Choose the white heat or black heat
palette.
Condensation on camera lens. Place camera in a dry area
at room temperature until condensation evaporates.
No video on the monitor The lens cap is on. Remove lens cap.
Condensation on camera lens. Place camera in a dry area
at room temperature until condensation evaporates.
The camera is not powered on. Power on the camera.
The monitor is not turned on or improperly connected to the
camera. Properly connect the monitor with the camera.
Turn on the monitor and choose a proper video mode.
The video mode of the monitor is not proper. Choose the
same video mode as output mode of the camera.