User manual

User Manual
Infrared Video
General Information
The infrared video with temperature information taken by MobIR
®
M8 can be transferred to PC via 2GB mini SD card or through USB2.0 for
further analysis by Guide IR software. The Infrared video function is displayed in the computer and controlled by the Guide IR Analyser. Before
the communication please install the USB driver and IR Analyser into your computer.
PC System Requirements
Operating system: Window 2000 or higher (IE5.0 or higher)
Software: Microsoft
®
Office 2000 or higher
Hardware:
Processor Pentium 4 2.4G or Above
RAM At least 512M
Others Independent Graphic Card
Using commands for infrared video analysis
After connecting the camera of MobIR
®
M8 to the PC and operate the IR Analyser, you can use the relative commands to do all kinds of
analysis and remote control the MobIR
®
M8.
Video Command
Use this command to get infrared video from MobIR
®
M8 directly or directory path of the PC where the films are saved
 Device Video
Make sure the camera of MobIR
®
M8 is under normal working status and connect the MobIR
®
M8 with the PC via USB2.0 to activate this
command; it will bring a dialog box as following
Select M8 and press ok to confirm, the infrared video is open as following
 Open Film
Use this command to open the saved Video file in the directory path of PC. The software will play this file and further analysis can be done on it.
46