User manual

User Manual

Introduction

This publication provides the necessary information required to safely operate the MOBIR® M8 Thermal Camera.

It is important to fully check all equipment with which you have been supplied.

The equipment should be used, maintained and serviced by suitably trained personnel, capable of carefully following the procedures and

guidelines given in this User Manual.

All User Manuals and leaflets should be read thoroughly before proceeding with operation of the equipment.

It is also advisable that all User Manuals and Instruction Leaflets supplied are kept readily available, for reference when the equipment is in

general use.

Precautions

The following precautions must be adhered to at all times and must be considered in addition to any advised precautions issued at the relevant

worksite or work area.

 Keep the MOBIR® M8 Thermal Camera steady during operation.

 Do not use the MOBIR® M8 Thermal Camera in temperature exceeding its working and storage temperature ranges.

 Do not direct the MOBIR® M8 Thermal Camera at very high intensity radiation sources such as the sun, carbon dioxide lasers or arc

welders etc.

 Do not expose the MOBIR® M8 Thermal Camera to dust and moisture. When operating the unit near water, ensure that the unit is

adequately guarded against splashes.

 When the MOBIR® M8 Thermal Camera is not in use or is to be transported, ensure that the unit and its accessories are stored in the

protective carry case.

 Do not jam the holes or loudspeaker on the camera body.

 Do not re-switch on the camera until 15 seconds later after switching it off.

 Do not throw, knock or vibrate intensely the camera and its components in order to keep them from damage.

 Do not attempt to open the camera body, as this action will void the warranty.

 Keep the SD memory card for the exclusive use of the camera.

The MOBIR® M8 Thermal Camera utilizes a Lithium Ion (Li-Ion) rechargeable battery pack. The following safety precautions must be adhered to

at all times to ensure the safe use of this equipment.

 Do not disassemble or attempt to open the battery under any circumstances.

 Do not expose the battery to fire or high temperatures.

 Do not short circuit the battery.

 Do keep the battery off moisture or water.

 Charging of the battery should only be carried out using the recommended or supplied charging device.

Maintenance

To ensure that the MOBIR® M8 Thermal Camera is kept in good working condition and remains fully operational, the following guidelines should

be adhered to at all times.

Non-optical surfaces

The non-optical surfaces of the camera can be cleaned when required, with a soft cloth dampened with water and a mild detergent.