User manual

User Manual
7
EASIR-0 Charging Instruction
How to use the batteries
 Insert the batteries, the indicator will not flicker at once. Press button to make the red indicator flicker ，
after 2 seconds , the indicator will alternatively flickers as green and red and stop when entering the self-check
interface.（If the camera is powered on when battery is low, the red indicator will flicker quickly and power off
automatically.
 When using the camera, if the batteries consume to the lowest limitation, the red indicator will flicker for a moment
then power off automatically.
Note:
 When using the battery，only when powering on and in the low battery condition, the indicator will light on.
How to charge with batteries
- Charge the batteries with battery charger only.
Note:
 Please choose qualified rechargeable batteries and battery charger.
Buttons Introduction
There are three functional buttons of GUIDE® EASIR-0（From left to right, they are ， and ）
and a trigger button “T”.
Power on /off the camera
The input voltage is 9V，keep button depressed for more than 3 seconds to power on. When powering off,
keep the button depressed until the switch off bar runs fully. To release the button at any time before
the switch off bar runs fully to leave the power off state.
Focus
In the non-menu state, press to enter focus menu, the following info will be displayed on the screen：
Far
Near
According to the attention, press to focus far, press focus near. Press T or to exit.
Quick function
In the non-function state, long-pressing the to switch between the manual mode and automatic mode, and