User`s guide

addressed with one command. For example, if plugs 3, 4 and 5 have been named "ATMSWTCH", then all three plugs
can be switched with the same command as shown below:
/ON ATMSWTCH or /BOOT ATMSWTCH
5.4. The Default Command
The Default Command (/D) sets all plugs to their default On/Off status. The default status is set using the Plug Parameters
menus described in Section 4.5. Plugs will be set to these defaults when /D is invoked, or after a power interruption. To set
all plugs to defaults, type /D and press [Enter].
Note:
When User Mode is active, this command will only be applied to plugs owned by the User's
password. The command will not be applied to plugs owned by other passwords.
●
When the System Mode is active, this command will be applied to all eight plugs.●
This command will always be applied to all owned plugs. It cannot be applied to only one plug.●
5.5. Other Commands
5.5.1. Login as Different User
The /R command is used to re-login using a different password. When invoked, the NPS will display the password prompt,
allowing the user to enter a different password in order to access other plugs or command functions. The /R command can
be used to switch from User Mode to System Mode.
The /R command is available in both System Mode and User Mode. To login as a different user, type /R, press [Enter],
and then key in a different valid password at the prompt. To suppress the "Sure?" prompt, type /R,Y [Enter].
5.5.2. Reset Network Port
The /T command is used to reinitialize the NPS Network card. The /T command is not available in User Mode. To reset
the Network Port, type /T and press [Enter]. To suppress the "Sure?" prompt, type /T,Y [Enter].
Note:
The /T command can only be issued via the Console Port or Modem Port. The /T command can not be
invoked via the Network Port.
5.5.3. Exit / Disconnect
To exit from the NPS Command Mode and discontinue connection to the unit, type /X and press [Enter]. The NPS will
display the "DISCONNECT" message. To suppress the "Sure?" prompt, type /X,Y [Enter].
5.6. Operating Tips
NPS Series Network Power Switch -- User's Guide
file:///C|/WEBPAGE/guides/nps/NPSGUIDE.HTM (17 of 20) [12/1/1999 3:00:04 PM]