User`s guide

The User Status Screen (Figure 10), displays only the On/Off status and parameters for plugs owned by the User's

password. Communication parameters are not listed.

Network Power Switch v2.02 Site: WESTERN TELEMATIC, INC.

------+------------------+--------+------------+------------------+---------

1 | ROUTER_A | ON | 15 Sec | ZEBRA | ON

2 | ROUTER_B | OFF | 15 Sec | ZEBRA | OFF

3 | DSU/CSU | ON | 10 Sec | XRAY | ON

4 | ATMSWITCH_A | ON | 10 Sec | ALPHA | ON

5 | ATMSWITCH_B | ON | 10 Sec | ALPHA | OFF

6 | LINUX_1 | ON | 5 Sec | XRAY | ON

7 | LINUX_2 | ON | 30 Sec | XRAY | OFF

8 | GATEWAY | ON | 30 Sec | (none) | ON

------+------------------+--------+------------+------------------+-------

"/H" for Help

Communication Settings: 9600,N,8,1

Modem Init. String: ATE0M0Q1&C1&D2S0=1

Modem Disc. String: +++ATZ

MAC Address: 00-c0-f0-27-a4-a5

IP Address: 192.1.1.5 Disconnect Timeout: 30 Min

Subnet Mask: 255.255.255.0 Command Echo: OFF

Gateway Mask: 192.1.1.1 Plug Confirmation: ON

Figure 9: System Status Screen

Network Power Switch v2.02 Site: WESTERN TELEMATIC, INC.

------+------------------+--------+------------+------------------+---------

3 | DSU/CSU | ON | 10 Sec | XRAY | ON

6 | LINUX_1 | ON | 5 Sec | XRAY | ON

7 | LINUX_2 | ON | 30 Sec | XRAY | OFF

------+------------------+--------+------------+------------------+---------

"/H" for Help

Figure 10: User Status Screen

5.3. Boot/On/Off Commands

These commands are used to Boot or change the On/Off status of the NPS's eight switched plugs. Commands can be

applied to one, several or all owned plugs. Plugs may be specified by name or number.

Note:

When User Mode is active, commands will only be applied to plugs owned by the User's password.

Commands will not effect plugs owned by other users.

●

When System Mode is active, commands can be applied to all eight switched plugs.●

Wait for the "NPS>" prompt to appear before entering commands. The prompt will not reappear

until the previous command is complete.

●

Commands are not case sensitive. All commands are invoked by pressing [Enter].●

Switch Plug(s) On: To power-on a plug, type /ON n and press [Enter]. Where "n" is the number or name of

the desired plug. For example:

/ON 1 or /ON ROUTER

NPS Series Network Power Switch -- User's Guide

file:///C|/WEBPAGE/guides/nps/NPSGUIDE.HTM (15 of 20) [12/1/1999 3:00:04 PM]