Installation guide

Section 3.1:Steps for Installing and Initializing the Cluster Software 61

Primary quorum partition: /dev/raw/raw1

Shadow quorum partition: /dev/raw/raw2

Heartbeat channels: 1

Channel type: net, Name: storage1

Power switch IP address or hostname: storage1

Identifier on power controller for member storage1: storage1

--------------------------

Power Switch 0 Information

--------------------------

Power switch IP address or hostname: storage0

Type: RPS10

Password: 10

--------------------------

Power Switch 1 Information

--------------------------

Power switch IP address or hostname: storage1

Type: RPS10

Password: 10

Save the cluster member information? yes/no [yes]:

Writing to configuration file...done

Configuration information has been saved to /etc/cluster.conf.

----------------------------

Setting up Quorum Partitions

----------------------------

Running cludiskutil -I to initialize the quorum partitions: done

Saving configuration information to quorum partitions: done

Do you wish to enable monitoring, both locally and remotely, via the \

Cluster GUI? yes/no [yes]: yes

----------------------------------------------------------------

Configuration on this member is complete.

To configure the next member, invoke the following command on that system:

# /sbin/cluconfig --init=/dev/raw/raw1

See the manual to complete the cluster installation