Installation guide

60 Chapter 3:Cluster Software Installation and Configuration
Enter hostname of the cluster member on heartbeat channel 0 \
[storage1]: storage1
Looking for host storage1 (may take a few seconds)...
Information about Quorum Partitions
Enter Primary Quorum Partition [/dev/raw/raw1]: /dev/raw/raw1
Enter Shadow Quorum Partition [/dev/raw/raw2]: /dev/raw/raw2
Information About the Power Switch That Power Cycles Member ’storage1’
Choose one of the following power switches:
o NONE
o RPS10
o BAYTECH
o APCSERIAL
o APCMASTER
o WTI_NPS
Power switch [RPS10]: RPS10
Enter the serial port connected to the power switch \
[/dev/ttyS0]: /dev/ttyS0
Cluster name: Development Cluster
Cluster alias IP address: 10.0.0.154
Cluster alias netmask: 255.255.254.0
Serial port connected to the power switch \
[/dev/ttyS0]: /dev/ttyS0
Cluster name: Development Cluster
Cluster alias IP address: 10.0.0.154
Cluster alias netmask: 255.255.254.0
--------------------
Member 0 Information
--------------------
Name: storage0
Primary quorum partition: /dev/raw/raw1
Shadow quorum partition: /dev/raw/raw2
Heartbeat channels: 1
Channel type: net, Name: storage0
Power switch IP address or hostname: storage0
Identifier on power controller for member storage0: storage0
--------------------
Member 1 Information
--------------------
Name: storage1