Installation guide

Section 3.1:Steps for Installing and Initializing the Cluster Software 59
/sbin/cluconfig
Red Hat Cluster Manager Configuration Utility (running on storage0)
- Configuration file exists already.
Would you like to use those prior settings as defaults? (yes/no) [yes]: yes
Enter cluster name [Development Cluster]:
Enter IP address for cluster alias [10.0.0.154]: 10.0.0.154
--------------------------------
Information for Cluster Member 0
--------------------------------
Enter name of cluster member [storage0]: storage0
Looking for host storage0 (may take a few seconds)...
Enter number of heartbeat channels (minimum = 1) [1]: 1
Information about Channel 0
Channel type: net or serial [net]:
Enter hostname of the cluster member on heartbeat channel 0 \
[storage0]: storage0
Looking for host storage0 (may take a few seconds)...
Information about Quorum Partitions
Enter Primary Quorum Partition [/dev/raw/raw1]: /dev/raw/raw1
Enter Shadow Quorum Partition [/dev/raw/raw2]: /dev/raw/raw2
Information About the Power Switch That Power Cycles Member ’storage0’
Choose one of the following power switches:
o NONE
o RPS10
o BAYTECH
o APCSERIAL
o APCMASTER
o WTI_NPS
Power switch [RPS10]: RPS10
Enter the serial port connected to the power switch \
[/dev/ttyS0]: /dev/ttyS0
--------------------------------
Information for Cluster Member 1
--------------------------------
Enter name of cluster member [storage1]: storage1
Looking for host storage1 (may take a few seconds)...
Information about Channel 0