User`s guide

5-56

Basic Configuration

• AccountingPort: The Accounting Port number for the RADIUS function.

(Default = 1813)

• Debug: (Text Interface Only) When enabled, the VMR/NPS will put RADIUS debug

information into Syslog. (Default = Off)

• OneTimeAuth: This feature should be enabled when using Two Factor

Authentication with the One Time Password scheme enabled. When enabled, the

One Time Password will be valid for the time specified under the OneTime Auth

Timer parameter. (Default = Off)

• OneTimeAuthTimer: When the OneTime Auth parameter is enabled, this

parameter determines how long (in minutes) the One Time Password will be valid.

(Default = 5 Minutes)

• PingTest: Allows you to ping IP addresses or domain names that have been

defined via the RADIUS Parameters menus in order to check that a valid IP address

or domain name has been entered.

Notes:

• In order for the Ping Test feature to function, your network and/or firewall

must be configured to allow ping commands.

• In addition to the Ping Test feature, the /TEST command in the Text Interface

or the "Test" option in the Web Browser Interface can also be used to ping

any user defined IP address in order to make certain that the IP address is

responding.

5.9.10.1. DictionarySupportforRADIUS

The RADIUS dictionary file can allow you to define users and assign command access

rights and plug access rights from a central location. The RADIUS dictionary file,

"dictionary.wti" is included on the CDROM along with this user's guide. To install the

dictionary file on your RADIUS server, please refer to the documentation provided with

your server; some servers will require the dictionary file to reside in a specific directory

location, others will require the dictionary file to be appended to an existing RADIUS

dictionary file. The WTI RADIUS dictionary file provides the following commands: .

• WTI-Super - Sets the command access level for the user. This command provides

the following arguments:

0 = ViewOnly

1 = User

2 = SuperUser

3 = Administrator

For example, to set the access level to "SuperUser", the command line would be:

WTI-Super="2"