User`s guide

5-37
Basic Configuration
5.9.1. Network Port Parameters
In the Text Interface, these parameters are found in the main Network Configuration
menu In the Web Browser Interface, these parameters are found by placing the cursor
over the "Network Configuration" link on the left hand side of the screen, and then
clicking on the "Network Port Parameters" link in the resulting fly-out menu.
• AdministratorMode: Permits/denies port access to accounts that allow
Administrator or SuperUser level commands. When enabled (Permit), the port will
be allowed to invoke Administrator and SuperUser level commands, providing they
are issued by an account that permits them. If disabled (Deny), then accounts that
permit Administrator and SuperUser level commands will not be allowed to access
command mode via this port. (Default = Permit)
• LogoffCharacter: Defines the Logoff Character for this port. This determines
which command(s) must be issued at this port in order to disconnect from a second
port. (Default = ^X ([Ctrl] plus [X]).)
Note: The Sequence Disconnect parameter can be used to pick a one
character or a three character logoff sequence.
• SequenceDisconnect: Enables/Disables and configures the Resident Disconnect
command. Offers the option to either disable the Sequence Disconnect, or select a
one character, or three character command format. (Default = One Character).
Notes:
• The One Character Disconnect is intended for situations where the
destination port should not receive the disconnect command. When the
Three Character format is selected, the disconnect sequence will pass
through to the destination port prior to breaking the connection.
• When Three Character format is selected, the Resident Disconnect uses the
format "[Enter]LLL[Enter]", where L is the selected Logoff Character.
• InactivityTimeout: Enables and selects the Inactivity Timeout period for the
Network Port. If enabled, and the port does not receive or transmit data for the
specified time period, the port will disconnect. (Default = 5 Minutes).
• CommandEcho: Enables or Disables the command echo for the Network Port.
(Default = On).
• AcceptBreak: Determines whether the port will accept breaks received from the
attached device, and pass them along to a connected port. When enabled, breaks
received at this port will be passed to any port this port is connected to, and sent
to the device connected to the other port. When disabled, breaks will be refused at
this port. (Default = On.)
• MultipleLogins: (Text Interface Only) If the VMR/NPS is installed in an
environment that does not include communication via an open network (local
communication only), then the Multiple Logins parameter can be used to determine
whether or not multiple users will be able to communicate with the unit at the
same time. If this parameter is set to "Off" then only one user will be allowed to
communicate with the unit at a time. (Default = On.)