User`s guide

5-19
Basic Configuration
5.3.6. Scripting Options
The Scripting Options submenu provides access to parameters that are used to set up
the VMR/NPS unit for running various scripts.
Notes:
• To access Scripting Options parameters via the Text Interface, first type /F
and press [Enter]to display the System Parameters Menu, then key in the
number for the Scripting Options item and press [Enter].
• To access the Scripting Options parameters via the Web Browser Interface,
place the cursor over the "General Parameters" link, wait for the flyout menu
to appear, then click on the "Scripting Options" link.
The Scripting Options menu allows the following parameters to be defined:
• CommandConfirmation: Enables/Disables the Command Confirmation feature.
When enabled, a "Sure" prompt will be displayed before power switching and
reboot commands are executed. When disabled, commands will be executed
without further prompting. (Default = On.)
• AutomatedMode: When enabled, the VMR/NPS will execute switching and reboot
commands without displaying a confirmation prompt, status screen or confirmation
messages. For more information, please refer to Section 5.3.6.1 or Section 9.3.
(Default = Off.)
Note: When the Automated Mode is enabled, security functions are
suppressed, and users are able to access configuration menus and
control plugs without entering a password. If security is a concern and the
Automated Mode is required, it is recommended to use the IP Security feature
(Section 5.9.3) to restrict access.
• CommandPrompt: Allows the Text Interface command prompt to be set to either
MPC, IPS, NPS, NBB, VMR, CCM, RPC or the currently defined Site ID Message.
(Default for VMR units = VMR; Default for NPS units = NPS.)