User`s guide

4-3
Hardware Installation
4.4. Connecting the Network Cable
The Network Port is an RJ45 Ethernet jack, for connection to a TCP/IP network.
Connect your 100Base-T cable to the Network Port. Note that the VMR and NPS
include a default IPv4 format IP address (192.168.168.168) and a default IPv4 protocol
subnet mask (255.255.255.0.) When installing the VMR or NPS in a working network
environment, it is recommended to define network parameters as described in
Section 5.9.
4.5. Rack Mounting
To install a VMR or NPS Series unit in your equipment rack, attach the L-Brackets
included with the unit and then mount the unit in a vacant space in your equipment rack.
4.6. Emergency Shut Off Function
VMR/NPS Series units also include an Emergency Shut Off function, that can be used
to immediately shut off all VMR/NPS power outlets in case of emergency. For more
information regarding the Emergency Shut Off feature, please contact WTI Tech Support
at [e-mail].
This completes the VMR/NPS installation instructions. Please proceed to the next
Section for instructions regarding unit configuration.