User`s guide

3-1
3. Getting Started
This section describes a simplified installation procedure for the VMR/NPS series
hardware which will allow you to communicate with the unit in order to demonstrate
basic features and check for proper operation. In order to take full advantage of the
features provided by this unit it is recommended that you should also refer to the
remainder of this User’s Guide.
3.1. Installing the VMR or NPS Hardware
3.1.1. Apply Power to the VMR or NPS
Refer to power rating nameplate on the VMR or NPS unit, and then connect the unit to
an appropriate power source. Note that some VMR/NPS models feature two separate
AC inputs and two separate power branches, while others feature a single power inlet.
Connect power cable(s) to the Power Inlet(s), install the cable keeper(s) (as described in
Section 4.1.1), then connect the cables to an appropriate power supply.
Note: To determine the exact model number and power requirements for your
VMR or NPS unit, either refer to the nameplate on the back of the unit, or access
command mode as described in Section 5.1 and then type /J * and
press [Enter].
3.1.2. Connect your PC to the VMR or NPS
The VMR or NPS unit can either be controlled by a local PC, that communicates with the
unit via the SetUp port, controlled via external modem, or controlled via TCP/IP network.
In order to switch plugs or select parameters, commands are issued to the VMR or NPS
via either the Network Port or SetUp Port. Note that it is not necessary to connect to
both the Network and SetUp Ports, and that the SetUp Port can be connected to either a
local PC or External Modem.
• NetworkPort: Connect your 10Base-T or 100Base-T network interface to the VMR
or NPS Network port.
• SetupPort: Use the DX9F-WTI Adapter supplied with the unit to connect your PC
COM port to the VMR or NPS SetUp Port.
• ExternalModem: Use the optional DX9M-RJ-KIT (not included) to connect your
external modem to the VMR or NPS Setup (RS232) Port.