User`s guide

2-7
Unit Description
2.7. NPS Series - Front Panel
As shown in Figure 2.7, the NPS Series Front Panel includes the following components:
1. SetUpPort: An RJ45 RS232 serial port (DCE configuration) used for connection to
a local terminal or external modem, as described in Section 4.3.2. For a description
of the Setup Port interface, please refer to Appendix B.1.
2. "ON"Indicator: An LED which lights when power is applied to the VMR unit.
3. "RDY"Indicator: (Ready) Flashes if unit is ready to receive commands.
4. DefaultButton: Manually toggles outlets On/Off or resets unit to factory default
parameters as described in Section 2.9.
5. ResetButton: Reboots and/or resets the NPS to factory defaults as described in
Section 2.9.
Note: All Front Panel Button functions can also be disabled via the System
Parameters menu, as described in Section 5.3.
6. OutputStatusIndicators: LEDs light when corresponding outlet is switched On.
7. BranchACircuitBreakers: Two circuit breakers, which protect Branch A. One
circuit breaker protects outlets A1 through A4, and the other circuit breaker protects
outlets A5 through A8.
8. BranchBCircuitBreakers: Same as Item 7 above, except circuit breakers protect
outlets on Branch B. (Not present on NPS-8HS series units.)
www.wti.com
NPS-16
Network Power Switch
SETUP PORT
DEFAULT
OUTPUT STATUS
RESET
ON RDY
A1 A2 A3 A4 A5 A6 A7 A8
B1 B2 B3 B4 B5 B6 B7 B8
A1 - A4 A5 - A8
B5 - B8B1 - B4
1 2 3 4
5
6 8
7
Figure 2.7: NPS Series - Front Panel (Model NPS-16HD20-1 Shown)