User`s guide

17-8
Command Reference Guide
17.3.2. Control Commands
/X Exit Command Mode
Exits command mode. When issued at the Network Port, also ends the Telnet session.
Note: If the /X command is invoked from within a configuration menu, recently
defined parameters may not be saved. In order to make certain that parameters
are saved, always press the [Esc] key to exit from all configuration menus and
then wait until "Saving Configuration" message has been displayed and the
cursor has returned to the command prompt before issuing the /X command.
Availability: Administrator, SuperUser, User, ViewOnly
Format: /X [Enter]
/C Connect to Serial Port
When the RJ-45 SetUp Port has been configured as a Normal Mode Port as described in
Section 5.8, the /C command can be used to create a connection between the Network
port and the serial SetUp Port.
Notes:
• User level accounts can only connect to the SetUp Port when serial port
access is specifically permitted by the account.
• To terminate a port connection, either type ^X ([Ctrl] plus [X]) or invoke the
currently defined disconnect sequence.
Availability: Administrator, SuperUser, User
Format: /C 1 [Enter]