User`s guide

13-7
Operation via SNMP
13.5.4. Alarm Status
The status of the VMR/NPS unit's alarm functions can be retrieved and displayed using
the following commands:
Notes:
• When an alarm status command returns a zero (0), this indicates that the
alarm is inactive.
• When an alarm status command returns a one (1), this indicates that the
alarm is active (triggered.)
• alarmTables::alarmOverCurrentInitial - (VMR Series Units Only) Displays
the status of the Over Current (Initial) Line Alarm.
• alarmTables::alarmOverCurrentCritical - (VMR Series Units Only)
Displays the status of the Over Current (Critical) Line Alarm.
• alarmTables::alarmOverTemperatureInitial - Displays the status of the
Over Temperature (Initial) Alarm.
• alarmTables::alarmOverTemperatureCritical - Displays the status of the
Over Temperature (Critical) Alarm.
• alarmTables::alarmCircuitBreakerOpen - Displays the status of the Circuit
Breaker Open Alarm.
• alarmTables::alarmCommLoss - Displays the status of the Lost Communication
Alarm.
• alarmTables::alarmPingNoAnswer - Displays the status of the Ping-No-
Answer Alarm.
• alarmTables::alarmInvalidAccessLockout - Displays the status of the
Serial Port Invalid Access Lockout Alarm.
• alarmTables::alarmPowerCycle - Displays the status of the Power Cycle
Alarm.
• alarmTables::alarmPlugCurrent - (VMR Series Units Only) Displays the
status of the Plug Current Alarm.
• alarmTables::alarmLostOptoVoltage - (Dual Power Inlet Units Only)
Displays the status of the Lost Voltage Alarm.
• alarmTables::alarmNoDialtone - Displays the status of the No Dialtone
Alarm.
• alarmTables::alarmEmergencyShutoff - Displays the status of the
Emergency Shut Off feature. For more information regarding the Emergency Shut
Off feature, please contact WTI Tech Support at [e-mail].