User`s guide

9-5

Operation

9.2.2. Applying Commands to Several Plugs - Text Interface

As described below, switching and reboot commands can be applied to only one

Switched AC Outlet, or to an assortment of outlets.

Note: When switching and reboot operations are initiated, Boot/Sequence

Delay times will be applied as described in Section 5.7.

1. SwitchSeveralPlugs: To apply a command to several plugs, enter the numbers

of the desired plugs, separated by commas or plus signs. For example to switch

plugs A1, A3, and A4 Off, enter either of the following commands:

/OFF A1+A3+A4 [Enter]

/OFF A1,A3,A4 [Enter]

Note: In order for the "+" or "," operators to work, there must be no spaces

between the plug name or number and the plus sign or comma.

2. SwitchaSeriesofPlugs: To apply a command to a series of plugs, enter the

numbers for the plugs that mark the beginning and end of the series, separated by

a colon. For example to switch On plugs A1 through A4 enter the following:

/ON A1:A4 [Enter]

3. AllPlugs: To apply a command to all plugs, enter an asterisk in place of the name

or number. For example, to Boot all plugs, enter the following:

/BO * [Enter]

Note: When this command is invoked by a User level account, it will only be

applied to the plugs that are specifically allowed for that account.