User`s guide

Page 6
IPS-800/1600 Series; Quick Start Guide
2. Test Switching Functions: You may wish to perform the following tests in
order to make certain that the IPS is responding to commands.
a) Reboot Outlet: If you are communicating with the unit via the Web
Browser Interface, select the button in the “Boot” column for Plug 1,
and then click on “Apply.” If you are operating the unit via the Text
interface, type /BOOT 1 and press [Enter]. The status indicator
for Plug 1 should go off, pause for a moment, and then go back on,
indicating that the boot cycle has been successfully completed.
b) Switch Outlet Off: From the Web Browser Interface, select the button
in the “Off” column for Plug 1, and then click “Apply.” From the
Text Interface, type
/OFF 1 and press [Enter]. The status indicator
for Plug 1 should go Off, indicating that the command has been
successfully completed. Leave Plug 1 in the “Off” state, and then
proceed to the next step.
c) Switch Outlet On: From the Web Browser Interface, select the button
in the “On” column for Plug 1, and then click “Apply.” From the Text
Interface, type /ON 1 and press [Enter]. The status indicator for
Plug 1 should then go back On, indicating that the command has been
successfully completed.
3. Log Out: When you have finished communicating with the unit it is
important to always log off by issuing the appropriate IPS command, rather
than simply closing your Telnet or communications program. When you log
off using the proper IPS command, this ensures that the unit has completely
exited from command mode, and is not waiting for the inactivity timeout to
elapse before allowing additional connections.
a) Web Browser Interface: Click on the “Log Out” button.
b) Text Interface: Type /X and press [Enter].
This completes the Quick Start Guide for the IPS. Prior to placing the unit into
operation, it is recommended to refer to the IPS User’s Guide for important
information regarding advanced configuration capabilities and more detailed
operation instructions. If you have further questions regarding the IPS unit,
please contact WTI Customer Support as described in the User’s Guide.