WTI Part No.: 13502 Rev.
Warnings and Cautions: Installation Instructions Secure Racking If Secure Racked units are installed in a closed or multi-unit rack assembly, they may require further evaluation by Certification Agencies. The following items must be considered. 1. The ambient within the rack may be greater than room ambient. Installation should be such that the amount of air flow required for safe operation is not compromised. The maximum temperature for the equipment in this environment is 45°C.
1. Introduction This Quick Start Guide describes a simplified installation procedure for the IPS-800/IPS-1600 hardware, which will allow you to communicate with the unit in order to demonstrate basic features and check for proper operation. Note that this Quick Start Guide does not provide a detailed description of unit configuration, or discuss advanced operating features in detail.
IPS-800/1600 Series; Quick Start Guide Note that when the IPS is shipped from the factory, RS232 Port Parameters are set as follows: 9600 bps, 8 Data Bits, One Stop Bit, No Parity. Although the IPS allows these parameters to be easily redefined, for the purpose of this Quick Start procedure, it is recommended that you configure your communications program to accept these default parameters. 3.
IPS-800/1600 Series; Quick Start Guide Figure 1: Plug Status Screen - Web Browser Interface (Model IPS-800 Shown) Internet Power Switch v1.40h Site ID: (undefined) Plug | Name | Password | Status | Boot/Seq. Delay | -----+------------------+------------------+---------+-----------------+ 1 | (undefined) | (undefined) | ON | 0.5 Secs | 2 | (undefined) | (undefined) | ON | 0.5 Secs | 3 | (undefined) | (undefined) | ON | 0.5 Secs | 4 | (undefined) | (undefined) | ON | 0.5 Secs | 5 | (undefined) | (undefined) | ON | 0.
IPS-800/1600 Series; Quick Start Guide 2. 3. Test Switching Functions: You may wish to perform the following tests in order to make certain that the IPS is responding to commands. a) Reboot Outlet: If you are communicating with the unit via the Web Browser Interface, select the button in the “Boot” column for Plug 1, and then click on “Apply.” If you are operating the unit via the Text interface, type /BOOT 1 and press [Enter].
IPS-800/1600 Series; Quick Start Guide FCC Part 15 Regulation This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
5 Sterling • Irvine • California 92618 (949) 586-9950 • Toll Free: 1-800-854-7226 Fax: (949) 583-9514 • http://www.wti.
