WTI Part No.: 13499 Rev.
Warnings and Cautions: Installation Instructions Secure Racking If Secure Racked units are installed in a closed or multi-unit rack assembly, they may require further evaluation by Certification Agencies. The following items must be considered. 1. The ambient within the rack may be greater than room ambient. Installation should be such that the amount of air flow required for safe operation is not compromised. The maximum temperature for the equipment in this environment is 45°C.
APS-8M Asynchronous Port Switch; Quick Start Guide 1. Introduction This Quick Start Guide describes a simplified installation procedure for the APS-8M hardware, which will allow you to communicate with the unit in order to demonstrate basic features and check for proper operation. Note that this Quick Start Guide does not provide a detailed description of unit configuration, or discuss advanced operating features in detail.
APS-8M Asynchronous Port Switch; Quick Start Guide 3. Communicating with the APS-8M The APS-8M command mode allows you to check unit status, change configuration parameters and connect and disconnect ports (including the Modem Port.) 1. Access Command Mode: Start your communications program and press [Enter]. The "APS>" Command prompt should appear, indicating that you have successfully accessed the APS-8M command mode.
APS-8M Asynchronous Port Switch; Quick Start Guide PORT STATUS: APS-M, Version 3.
APS-8M Asynchronous Port Switch; Quick Start Guide 5. Exit Command Mode: At the "APS>" command prompt, type /X and press [Enter]. The APS-8M will exit command mode. 6. Access Command Mode via Modem: From a PC with a modem and Telco line, dial the number for the line which is connected to the APS-8M’s internal modem. Once the connection is established, the unit should send the "APS>" command prompt, indicating that you have successfully accessed command mode.
APS-8M Asynchronous Port Switch; Quick Start Guide FCC Part 15 Regulation This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the equipment is operated in a commercial environment.
5 Sterling • Irvine • California 92618 (949) 586-9950 • Toll Free: 1-800-854-7226 Fax: (949) 583-9514 • http://www.wti.
