User`s guide

/W Display Port Parameters (Who)
Displays configuration of an individual port, but does not allow
the user to change parameters. Ports with User Level command
capability cannot display parameters for other ports. Normally,
the Port Parameters screen will not include the Port Password.
Note however, that when the Supervisor Mode is active, the /WP
option can be used to display the password for the target port.
For more information, please refer to Section 7.3.
Availability: Supervisor / User
Format: /W[P] [x] [Enter]
Where:
P When the “P” option is included (e.g. /WP 5), the Port
Parameters screen will list the password for the port, if
defined. (Supervisor Mode Only).
x Port number or name. If the "x" argument is omitted,
parameters for your resident port will be displayed.
Response: Displays port parameters.
Example: To display parameters for a port named "SERVER",
access the Command Mode from a port with Supervisor Level
command capability, and type /W SERVER [Enter].
/X Exit Command Mode
Exits Command Mode. When issued at the Net Port, also ends
the telnet session. Note that exiting from Command Mode will
not terminate port connections.
·
Any-to-Any Mode: Exits Command Mode.
·
Modem Mode: Disconnects and resets modem, hang-up
message is sent, hardware line to modem drops for 500 ms,
and modem reset string is sent.
Availability: Supervisor / User
Format: /X [Enter]
Response: Disconnected
11-10
APS-8M User’s Guide