User`s guide

/C Connect
Establishes a bi-directional connection between two ports. For
more information and command line examples, please refer to
Section 8.1. There are two different types of port connections:
·
Resident Connect: If the /C command specifies one port
name or number, your resident port will be connected to the
specified port.
·
Third Party Connect: If the /C command specifies two
port names or numbers, the unit will connect the two ports
indicated. A Third Party Connect command must be issued
from a third port with “Supervisor” command capability.
"User" ports cannot initiate a Third Party Connect.
Note:
·
Ports with "User" command capability can only
connect to ports that share the same Port Password.
·
Ports with “Supervisor” command capability are
allowed to connect to all other ports.
Availability: Supervisor / User
Format: /C <x> [x] [Enter]
Where x is the number or name of the port(s) to be connected.
Response:
Verbose: Connected xx, when a Resident Connection is
initiated, the APS will also display the currently selected
Resident Disconnect Sequence for your port.
Terse: 1
/CP Copy RS232 Port Parameters
Allows quick set-up when all APS RS232 ports will be
configured with the same or similar parameters. When the /CP
command is invoked, the APS will display a menu that is used to
select common port parameters, which can then be copied to all
APS RS232 ports. Note that the Copy Command will not change
restricted parameters at Ports 1, 2, and 8. For more information,
please refer to Section 5.6.
Availability: Supervisor Only
Format: /CP [Enter]
Response: Displays Copy Parameters Menu
11-5
Command Reference Guide