User`s guide

11.2. Command Response
When commands are sent to the APS-8M, the unit can respond
with either verbose (English Text) or terse messages (numeric /
abbreviated). The default message type for all ports can be set to
either terse or verbose using SetUp Switch Six.
After the unit is installed and configured, the port configuration
command (/P) can specify an individual response format for each
port. In addition to the Terse and Verbose response modes, the
port configuration commands can also select the Quiet Mode.
When the Quiet Mode is selected, the port will not send
messages in response to commands.
The table below summarizes the various response messages for
both the Terse and Verbose modes.
Terse Verbose
0OK
0 RAM Test Passed
1 Connected *
2 Busy
3 Disconnected
4 Invalid Command
5 Are You Sure (Y/N) ?
6 Invalid Parameter
7 Invalid Syntax
8 Invalid Access
9 Enter Site ID:
A Aborted
B Enter Password:
C Invalid Password
D RAM Test Failed at *
E Inactivity Timeout, Disconnected
F Data in Buffer from Previous Connection ...
Re-Enter Logoff Sequence to Purge Buffer.
G Asleep
* These verbose Response Messages include additional
information not provided by terse Response Messages.
11-2
APS-8M User’s Guide