User`s guide

4. The APS-8M will send a series of ASCII command lines
which specify the currently selected APS parameters. The
last line of the file should end with a “/G-00” command.
When the download is complete, press [Enter] to return to
the "APS>" command prompt.
9.2. Restoring Saved Parameters
This section describes the procedure for using your
communications program to send stored parameters to the APS.
1. Start your communications program and access the APS
Command Mode; if the password prompt is displayed, enter
the Supervisor Password.
2. Configure your communications program to upload an
ASCII text file.
3. Upload the ASCII text file with the saved APS parameters.
If necessary, key in the file name and directory path.
4. Your communications program will send the specified
ASCII text file to the APS-8M. When the communications
program is finished with the upload, make certain to
terminate the Upload mode.
Note: If the APS detects an error in the parameters
file, it will respond with the “Invalid Parameter”
message. If an error message is received, carefully
check the contents of the parameters file, correct the
problem, and then repeat the upload procedure.
5. If the parameter upload procedure is successful, the APS
will send a confirmation message, and then return to the
"APS>" command prompt. Type /S and press [Enter], the
APS Status Screen will be displayed. Check the Status
Screen to make certain the unit has been configured with
the saved parameters.
9-2
APS-8M User’s Guide