User`s guide

7.3. The Port Parameters Screens (/W)
The /W command displays more detailed information about an
individual APS port. Rather than listing connection information
for all ports like the Port Status Screens, the Port Parameters
screen lists all defined parameters for a specific port.
The /W command is available in both Supervisor Mode and User
Mode. Note however, that when you log in with a Port (User)
password, the APS will only display information regarding your
resident port.
If the Supervisor Mode is active, the Port Parameters Screens
offer the option to either display or suppress Port Passwords.
Normally, when /W is invoked, the Password field will read
either “defined” or “undefined”, depending upon whether or not
the port’s password has been specified. To display the Port
Parameters Screen with the Port Password, type /WP, followed
by the desired port number, and then press [Enter]. Note that
the /WP command option is not available in User Mode.
7-5
The Status Screens
PORT PARAMETERS #03:
1. Port Name: (undefined)
2. Password: (undefined)
3. Baud Rate: 9600
4. Bits/Parity: 8-None
5. Stop Bits: 1
6. Handshake Mode: RTS/CTS
7. Port Mode: Any-to-Any
74. DTR Output: Pulse
8. Supervisor Mode: Permit
9. Logoff Character: ^X
10. Sequence Disconnect: One Character
11. Timeout Disconnect: Off
12. Response Type: Verbose
13. Command Echo: On
14. Accept Break: Yes
Enter: "<" previous port,
">" next port,
<ESC> exit ...
Figure 7.3: The Port Parameters Screen